pro engineer install and run problem
pro engineer install and run problem
(OP)
i ve installed and run pro e wildfire 2 succesfully ,also made a project ,when suddendly it stop functioning. i run the programm and after a few sec a message pops out ''the pro e stoped functioning ''.I try to install pro e wildfire 4 and at the very begining the same message pops out. Does anybody has any idea whats wrong??? I have a laptop acer extensa 5230 win vista basic.RAM 1,50 celeron 2.00 GHz





RE: pro engineer install and run problem
A better operating system is a must, Vista is no good.
As a comparison, I use a Dell Precision M6400 with 16 GB of ram, dual core processor.
If the problem is with Pro Engineer itself, Pro Engineer shuts down without warning and with no explaination of the problem.
RE: pro engineer install and run problem
Your computer is underpowered for Pro/E and I am guessing you have an Intel built-in graphics chip. VISTA is a resource hog compared to XP and Win7.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
RE: pro engineer install and run problem
RE: pro engineer install and run problem