NX7.5 CAST tutorial part
NX7.5 CAST tutorial part
(OP)
Hi all,
I'm just going through the CAST tutorials and I'm having a problem with a part.
The section of the course is "Splines" and the part I'm having trouble with is spline_1.prt located in the curves folder (found on CAST).
When I open the part I am supposed to get an image of a mobile (cell) phone, but what appears is a just a few points (about 20 of these things =>+). What do I needed to do to get the correct image onscreen?
Thanks
I'm just going through the CAST tutorials and I'm having a problem with a part.
The section of the course is "Splines" and the part I'm having trouble with is spline_1.prt located in the curves folder (found on CAST).
When I open the part I am supposed to get an image of a mobile (cell) phone, but what appears is a just a few points (about 20 of these things =>+). What do I needed to do to get the correct image onscreen?
Thanks





RE: NX7.5 CAST tutorial part
Anthony Galante

Senior Support Engineer
NX4.0.4MP10, NX5.0.0->5.0.6, NX6.0.0->NX6.0.5, NX7.0.0->NX7.0.1 & NX7.5.0.32-> NX7.5.2.5, Beta NX8.0.0.15
RE: NX7.5 CAST tutorial part