Populating MS Access dbase with 3D Tray
Populating MS Access dbase with 3D Tray
(OP)
This question is pertaining to Microstation V8i.
I have followed the steps of setting up a link to a database using; settings/database/connect (to connect to a new database) and settings/database/setup to add the MSCATALOG and MSFORMS database with the MSLINK column required to link Microstation objects to the database but I can't figure out how to start populating the database with entities from the dgn file. Could someone please help with this? or direct me to a paper that can step me throw how to do this?
Thanks
I have followed the steps of setting up a link to a database using; settings/database/connect (to connect to a new database) and settings/database/setup to add the MSCATALOG and MSFORMS database with the MSLINK column required to link Microstation objects to the database but I can't figure out how to start populating the database with entities from the dgn file. Could someone please help with this? or direct me to a paper that can step me throw how to do this?
Thanks





RE: Populating MS Access dbase with 3D Tray
http
HTH,
Bob Mecham
Training | Consulting | Programming
www.EnvisionCAD.com
Facebook: http://www.facebook.com/EnvisionCAD
Twitter: http://twitter.com/envisioncad
Youtube: http://www.youtube.com/user/envisioncad