Flyouts flying away
Flyouts flying away
(OP)
The flyouts I'm talking about are like those in Weldments, the little grey boxes when you trim/extend:
[ Body 1,1: keep ]
When I click on one, they all jump to the other side of my model. Then I'm forced to pan around until I find them, and by that point I can't even see which tail goes to which cut section.
Is there a way to force pull them all back to the screen?
Or is there a way to have them more intelligently show up?
[ Body 1,1: keep ]
When I click on one, they all jump to the other side of my model. Then I'm forced to pan around until I find them, and by that point I can't even see which tail goes to which cut section.
Is there a way to force pull them all back to the screen?
Or is there a way to have them more intelligently show up?
Devon Murray, EIT [Mechanical]
Solidworks 2011 SP 2.0






RE: Flyouts flying away
Jeff Mirisola, CSWP
Design Manager/Senior Designer
M9 Defense
My Blog