Standard Built-In Fastener Hole Feature Tables Available In Catia
Standard Built-In Fastener Hole Feature Tables Available In Catia
(OP)
Using Catia V5R18;
Are there standard built-in table features available in Catia, like they are available in SolidWorks?
It doesn't make sense that every time I want to create a Counter-bore or Counter-sink feature, I either have to know the parameters or look at pre-determined tables to get the parameters.
Any response will be greatly appreciated!
Are there standard built-in table features available in Catia, like they are available in SolidWorks?
It doesn't make sense that every time I want to create a Counter-bore or Counter-sink feature, I either have to know the parameters or look at pre-determined tables to get the parameters.
Any response will be greatly appreciated!





RE: Standard Built-In Fastener Hole Feature Tables Available In Catia
Some people with that have the knowledge based licenses create User Defined features that are linked to pre-determined tables.
Regards,
Derek