File schema in STEP file does not compute
File schema in STEP file does not compute
(OP)
Am having difficulty importing a 100Mb STEP file from Autodesk Inventor into NX7. Getting a failure message that the schema may not be right. Where does the NX7 importer look for a schema file? Is there a better intermediate exchange format? Should I look for a direct translator? Could use a pointer to a good place to turn for expert help. Thanks in advance.





RE: File schema in STEP file does not compute
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: File schema in STEP file does not compute
RE: File schema in STEP file does not compute