inspection gage for boss true position
inspection gage for boss true position
(OP)
I need some advices on making gage for true position of boss; let say I have a boss diameter 1.00+/.030 and true position is .020(RFS)/A/B/C . I like to make a plug gage with a hole, the plug gage is located on the tooling point fixture; what size of the hole should be so where the boss go into the hole of the plug; the boss location s/b ok. Thank





RE: inspection gage for boss true position
Dave D.
www.qmsi.ca
RE: inspection gage for boss true position
RE: inspection gage for boss true position
Dave D.
www.qmsi.ca