.prt file won't open directly in NX 7.5
.prt file won't open directly in NX 7.5
(OP)
After installing NX 7.5 on my new laptop I realized that all my .prt files still did not have a default program to open to but the .fem and .sim files were defaulted to opened in NX 7.5. So I set them to open with ugraf.exe in the install directory. Then I clicked the files and NX 7.5 opens to the main screen but my part will not load. If I open them from the software they load fine. It's not too big of a problem but I am just wondering if any knows how to make my .prt files open directly from where they are located.





RE: .prt file won't open directly in NX 7.5
ugraf.exe %1
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
RE: .prt file won't open directly in NX 7.5
RE: .prt file won't open directly in NX 7.5
regedit, then do a search for ugraf
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
RE: .prt file won't open directly in NX 7.5
Best of luck!
Jon Hackett
Taylor Hobson Ltd. (www.taylor-hobson.com)