Sheet Metal operation?...............................
Sheet Metal operation?...............................
(OP)
Hi,
Please, look at the magenta area. How could I create it in NX?
Thanks
Please, look at the magenta area. How could I create it in NX?
Thanks





RE: Sheet Metal operation?...............................
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Sheet Metal operation?...............................
Thanks for your message. I need to create the transition area. It seems to me to be a Sheet Metal operation, but I do not have much experience with that. There is an angle of torsion in that area(2.5 degree).
Thanks
RE: Sheet Metal operation?...............................
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Sheet Metal operation?...............................
RE: Sheet Metal operation?...............................
Thanks for your reply. I use NX6, I can't open your link.....Can you give me a written describtion of the steps, please?
Thanks
RE: Sheet Metal operation?...............................
RE: Sheet Metal operation?...............................
Thanks a lot. It looks nice. I was wondering if Sheet metal application has a feature (too) especially for this procedure......
What do you think?
Regards
RE: Sheet Metal operation?...............................