WRC 107 calc for other shapes
WRC 107 calc for other shapes
(OP)
Hi, not sure what happened but my thread didnt show up, so here it is again
I'm doing calculation for pipe linestops, and the materials are PFC, EA and UC.
Since the max stress occur at the corners, can I treat these shapes as rectangle when using WRC-107? or do I need different method of calculation?
ie: for 150PFC, I would assume it as rectangle of 150x75mm, etc
many thanks
I'm doing calculation for pipe linestops, and the materials are PFC, EA and UC.
Since the max stress occur at the corners, can I treat these shapes as rectangle when using WRC-107? or do I need different method of calculation?
ie: for 150PFC, I would assume it as rectangle of 150x75mm, etc
many thanks




