Unexploded parts
Unexploded parts
(OP)
Hi experts
I have a problem with an assembly.
I have recently added a new subassembly, and now I can not autoexplode the entire assembly, it only takes a few parts.
The new subassembly is not exploded.
And in the exploded pathfinder there are now unexploded parts.
I have tried to delete the old configurations but that did not help.
So my question is, how do I get the topassembly auto exploded??
Best regards
FSDS
I have a problem with an assembly.
I have recently added a new subassembly, and now I can not autoexplode the entire assembly, it only takes a few parts.
The new subassembly is not exploded.
And in the exploded pathfinder there are now unexploded parts.
I have tried to delete the old configurations but that did not help.
So my question is, how do I get the topassembly auto exploded??
Best regards
FSDS





RE: Unexploded parts
What is Engineering anyway: FAQ1088-1484: In layman terms, what is "engineering"?
RE: Unexploded parts
Well I think I know what was wrong, because when I put in the new subassembly I did not fully constrain it.
I just so to say dump it into the assembly.
I have now fully constrained the sub assembly and it seems to work.
I am now able to auto explode.
Best regards
FSDS