Proper Thread Cycle in CAM Post-processor and Real world
Proper Thread Cycle in CAM Post-processor and Real world
(OP)
Hello,
I am using UG NX 7.5.1.5 with the total machining bundle.
I want to run a proper G76 for threading. That way I can change things quickly, and I don't have to build the thread cycle line by line.
The attached file from the post builder help basically tells me that I can't do it the way I would like to
i.e. G76P112233
G76 X Z P Q F
But since this is such a standard issue I thought I'd ask how other places have dealt with this?![[ponder] ponder](https://www.tipmaster.com/images/ponder.gif)
Thanks.
--Buckshott00
I am using UG NX 7.5.1.5 with the total machining bundle.
I want to run a proper G76 for threading. That way I can change things quickly, and I don't have to build the thread cycle line by line.
The attached file from the post builder help basically tells me that I can't do it the way I would like to
i.e. G76P112233
G76 X Z P Q F
But since this is such a standard issue I thought I'd ask how other places have dealt with this?
![[ponder] ponder](https://www.tipmaster.com/images/ponder.gif)
Thanks.
--Buckshott00





RE: Proper Thread Cycle in CAM Post-processor and Real world
http://
http://