incorect display of surfaces in NX7
incorect display of surfaces in NX7
(OP)
Hi,
are there any settings in NX7 or problem is somethere else?
I am using latest drivers for my video card (ati fire gl5600, workstation hp hw4600).
nx7.0.1.7 mp2
winxp 32bit +sp3
512mb video ram
2gb system ram
are there any settings in NX7 or problem is somethere else?
I am using latest drivers for my video card (ati fire gl5600, workstation hp hw4600).
nx7.0.1.7 mp2
winxp 32bit +sp3
512mb video ram
2gb system ram





RE: incorect display of surfaces in NX7
RE: incorect display of surfaces in NX7
RE: incorect display of surfaces in NX7
Preferences -> Visualization Performance -> General Graphics
...and check in the 'Session Settings' section of the dialog to see that 'Backface Culling' is NOT toggled ON. If it is, toggle it OFF.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: incorect display of surfaces in NX7