HI all
HI all
(OP)
HI
How to creat a chamfer tool and How to generate a chamfer tool path
thax
How to creat a chamfer tool and How to generate a chamfer tool path
thax
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
|
RE: HI all
Do you want a chamfer tool with a sharp point or a flat at the bottom?
Fopr a sharp point create an end mill with a tip angle very simple. For a flat bottom tool create a taper angle. In most cases you may want to add a holder to the tool.
| | <- HOLDER
| |
------
\____/ <- TOOL
You can use these tools in any operation Planar mill, fixed or variable contour etc.
For a simple 2D chamfer use planar mill and make sure the boundary is at the top of the chamfer. Make the floor where you want the bottom of the tool to be and ue a profile pass.
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6.0.5.3
RE: HI all
It should pertain to the subject of your thread.