Reassociation of surface finish symbols in NX7
Reassociation of surface finish symbols in NX7
(OP)
Is it possible to reassociate surface finish symbols in NX7? What I need to do, then this associativity is already lost (eg, I added a chamfer to an edge) ?
Thanks
Nx7.0.1.7 mp2
win xp 32 bit +sp3
Thanks
Nx7.0.1.7 mp2
win xp 32 bit +sp3





RE: Reassociation of surface finish symbols in NX7
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Reassociation of surface finish symbols in NX7