Server Crash - Now I can't get PDM Workgroup running again
Server Crash - Now I can't get PDM Workgroup running again
(OP)
Hi All,
We have recently had a crash on our Network Storage Device and have lost all data on it. I have reinstalled the Workgroup server application and its now running.
Problem is I can't get any clients to see the vault.
We are using 2008 Office Professional SP4.0 for both.
Can Anyone help please?
We have recently had a crash on our Network Storage Device and have lost all data on it. I have reinstalled the Workgroup server application and its now running.
Problem is I can't get any clients to see the vault.
We are using 2008 Office Professional SP4.0 for both.
Can Anyone help please?






RE: Server Crash - Now I can't get PDM Workgroup running again
Jeff Mirisola, CSWP
Design Manager/Senior Designer
M9 Defense
My Blog
RE: Server Crash - Now I can't get PDM Workgroup running again
RE: Server Crash - Now I can't get PDM Workgroup running again
Check to see if there are two "Workgroups" program folders on the server. If there is, delete the new one.
Chris
SolidWorks 10 SP4.0
ctopher's home
SolidWorks Legion
RE: Server Crash - Now I can't get PDM Workgroup running again
StrykerTECH Engineering Staff
http://www.stryker-tech.com/
RE: Server Crash - Now I can't get PDM Workgroup running again
Thanks for the suggestions, all of the network addresses and names were ok.
I needed to set ports up for pdm access. Once this was done all was good.