Hole Wizard automatically "Fixes" location of first Point
Hole Wizard automatically "Fixes" location of first Point
(OP)
SW2006 & SW2010 on different computers...
It seems the HoleWizard wants to place the first hole and make it Fixed...the question is "why?"
I know I've run across this before and was able to change something to stop it from doing that, but I can't seem to find where the heck the mode is changed.
It seems the HoleWizard wants to place the first hole and make it Fixed...the question is "why?"
I know I've run across this before and was able to change something to stop it from doing that, but I can't seem to find where the heck the mode is changed.






RE: Hole Wizard automatically "Fixes" location of first Point
RE: Hole Wizard automatically "Fixes" location of first Point
Checked the Major Grid spacing, then took out the Minor spacings...still no change.
Shut off all Snap-To options, and the HW still Fixes the first point.
Seem like it was something that was not so intuitive....and I really can't recall for sure if it was even in the Tools>Options settings
Another pic with Grid On, but no Snap-To of any kind.
RE: Hole Wizard automatically "Fixes" location of first Point