Rigid body nodes replaced to a single node
Rigid body nodes replaced to a single node
(OP)
Hi all,
I have assigned all nodes of a discrete rigid body to a single node at reference point, say RP1. My question is that can I just pick this point, RP1, to introduce the restraint as boundary conditions rather than the actual nodes at the discrete rigid body itself? In another word, all nodes at discrete rigid body are replaced with RP1.
Thanks for any response.
helmi
I have assigned all nodes of a discrete rigid body to a single node at reference point, say RP1. My question is that can I just pick this point, RP1, to introduce the restraint as boundary conditions rather than the actual nodes at the discrete rigid body itself? In another word, all nodes at discrete rigid body are replaced with RP1.
Thanks for any response.
helmi





RE: Rigid body nodes replaced to a single node
yes thats right, ABAQUS only accepts boundary conditions to be applied to the reference node alone. The RP1 alone governs the displacement of the whole rigid body