Single point threading reinforced PEEK
Single point threading reinforced PEEK
(OP)
Anybody try single point threading Victrex 450CA30 extruded rod? Any tips would be appreciated (e.g. tooling, speeds, feed, etc.).
The external thread is a custom .2850-70 UNS-3A thread per ASME B1.1 if that helps illicit responses.
Looked through Victrex's processing guide, but found nothing specific. I'm thinking diamond tipped / coated inserts will be required.
The external thread is a custom .2850-70 UNS-3A thread per ASME B1.1 if that helps illicit responses.
Looked through Victrex's processing guide, but found nothing specific. I'm thinking diamond tipped / coated inserts will be required.





