How to bend an existing solid model
How to bend an existing solid model
(OP)
I have a solid model of a piece of flat steel with some bends in it. Near the end of the piece, I need to bend the edges at a 45 degree angle. Is there a way to do this without creating the whole part in Sheet Metal? Thanks.





RE: How to bend an existing solid model
RE: How to bend an existing solid model
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: How to bend an existing solid model
RE: How to bend an existing solid model
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.