UG NX3 part gives not a part file in UG NX6
UG NX3 part gives not a part file in UG NX6
(OP)
I recieved a disk that has UG parts on it and was instructed to make PDF of the drawings. Almost all of the files give an error that they are not part files but according to notepad they are NX parts. The ones I can open and get a part history on have this. NX 3.0.2.3- Madam5.0.0 and this. NX 3.0.2.3<!<OT_PUB>!>
Any one have any ideas on why I can't get this files to open?
Thank you
Mike Aylward
Any one have any ideas on why I can't get this files to open?
Thank you
Mike Aylward





RE: UG NX3 part gives not a part file in UG NX6
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: UG NX3 part gives not a part file in UG NX6
Be sure that the whole part name (including path) doesn't contain any special character like !@éè...
I hope this help
Regards
Didier Psaltopoulos
http://www.psi-cad.com