Inspection of Gas holders
Inspection of Gas holders
(OP)
Dear members,
Can anybody share with me the best method or the available method of inspecting gas holders? These gas holders stores the entire town gas for domestic use. I understand that there are various types of gas holders such as the water sealed and the piston type, however, what is the standard inspection that is normally carried out and specific NDT techniques available.
Any response and information is very much appreciated.
Can anybody share with me the best method or the available method of inspecting gas holders? These gas holders stores the entire town gas for domestic use. I understand that there are various types of gas holders such as the water sealed and the piston type, however, what is the standard inspection that is normally carried out and specific NDT techniques available.
Any response and information is very much appreciated.





RE: Inspection of Gas holders
RE: Inspection of Gas holders
I can sketch one from memory, except for the water seal, which might take a few minutes to figure out, but I have no idea how to inspect them. ... other than 'carefully'.
Mike Halloran
Pembroke Pines, FL, USA
RE: Inspection of Gas holders
RE: Inspection of Gas holders
Mike Halloran
Pembroke Pines, FL, USA