Dead Links
Dead Links
(OP)
Hi. I am in the process of switching to 3 from 6. I have this issue where all of my links go dead when I move a sub assembly and I cant get them to update.
I have a dieshoe assembly from my library and it is expression driven. Once I start adding fasteners and whatnot if I have to move the dieshoe....all links to it die. I try and do an update and nothing. I find that I have to go back one at a time edit every single link. I don't understand why this is. In 3 it always just updated.
This is costing me huge amounts of time.
Anyone else ave this happen. Is there a setting I am missing?
Thanks.
I have a dieshoe assembly from my library and it is expression driven. Once I start adding fasteners and whatnot if I have to move the dieshoe....all links to it die. I try and do an update and nothing. I find that I have to go back one at a time edit every single link. I don't understand why this is. In 3 it always just updated.
This is costing me huge amounts of time.
Anyone else ave this happen. Is there a setting I am missing?
Thanks.





RE: Dead Links
PR1795905 & PR1798227: The problem in Assemblies where legacy wave links were broken is fixed.
Kal G.
NX6.0.5.3 MP4
P.B 6.0.3
P.B 7.5.2
RE: Dead Links
Some aspects yes, but others no.
NX 6.0.5.3
Windows XP32
RE: Dead Links
I am on 6.0.4.3
Thanks.