heli-coil thread definitions for NX
heli-coil thread definitions for NX
(OP)
Does anyone have the heli-coil thread definitions for the thd_english.dat and thd_metric.dat NX files?
NX6.0.4.3 mp02, Windows XP 32-bit,Team Center 9.1
Running cad straight out of the box is OK but, a system tuned with application software is the best way to increase productivity.





RE: heli-coil thread definitions for NX
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: heli-coil thread definitions for NX
NX6.0.4.3 mp02, Windows XP 32-bit,Team Center 9.1
Running cad straight out of the box is OK but, a system tuned with application software is the best way to increase productivity.
RE: heli-coil thread definitions for NX
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: heli-coil thread definitions for NX
NX6.0.4.3 mp03, Windows XP 32-bit,Team Center 9.1
Running cad straight out of the box is OK but, a system tuned with application software is the best way to increase productivity.
RE: heli-coil thread definitions for NX
As for changing the Hole type (which BTW was NOT a regression from pre-NX 5.0), that will not be supported until NX 8.0, which is still a long ways off.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: heli-coil thread definitions for NX
NX6.0.4.3 mp03, Windows XP 32-bit,Team Center 9.1
Running cad straight out of the box is OK but, a system tuned with application software is the best way to increase productivity.