Using Quick Extend in NX6 on "Added Existing Curve"
Using Quick Extend in NX6 on "Added Existing Curve"
(OP)
I am using NX6. Is it possible in sketch, to use the "quick extend" option on an "added existing curve". It doesnt seem to work and Im wondering if I need to change a setting or something. Thanks everybody.





RE: Using Quick Extend in NX6 on "Added Existing Curve"
RE: Using Quick Extend in NX6 on "Added Existing Curve"
RE: Using Quick Extend in NX6 on "Added Existing Curve"
I do not think the fact that it is an "add existing curve" is a factor, it must be something else.
RE: Using Quick Extend in NX6 on "Added Existing Curve"
RE: Using Quick Extend in NX6 on "Added Existing Curve"
RE: Using Quick Extend in NX6 on "Added Existing Curve"
RE: Using Quick Extend in NX6 on "Added Existing Curve"
RE: Using Quick Extend in NX6 on "Added Existing Curve"
RE: Using Quick Extend in NX6 on "Added Existing Curve"