user message in NX6 integrated to Teamcenter while statusing
user message in NX6 integrated to Teamcenter while statusing
(OP)
Hi All,
NX6 and Teamcenter 2005SR1..
When user tries to do save as to next revision and , if the previous revision is not statused, NX gives messages saying " part not loaded" instead of " exceeding the 1 open revision limit" which it used to give in NX4.
Any one noticed it
NX6 and Teamcenter 2005SR1..
When user tries to do save as to next revision and , if the previous revision is not statused, NX gives messages saying " part not loaded" instead of " exceeding the 1 open revision limit" which it used to give in NX4.
Any one noticed it




