NX7 improvements over NX5
NX7 improvements over NX5
(OP)
We've just moved over to NX7 from using NX5. While synchronous modeling is great, I have to say we're not really fond of the changes to mating conditions (assembly constraints). Does anyone out here have anything they like in NX7 better than in NX5?





RE: NX7 improvements over NX5
RE: NX7 improvements over NX5
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX7 improvements over NX5
But what happended to the modeling toggles toolbar ?
RE: NX7 improvements over NX5
To enable the toolbar go to...
Tools -> Customize...
...and when the dialog comes up, select the 'Toolbars' tab and then select the last button on the right labeled 'Load'. Now navigate to the UGII\Menus folder and select the 'ug_modeling_toggles.tbr' file, hit OK, when the Customize dialog comes up, scroll to the bottom and toggle on the Modeling Toggles toolbar and you're good to go.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX7 improvements over NX5
RE: NX7 improvements over NX5
Al