White patches on clear parts
White patches on clear parts
(OP)
Hi folks,
I'm making some thin-walled containers via stretch blow moulding out of clear PEBA and Nylon 12. On some runs, some of the parts have silvery-white patches on them, especially around bends and edges (ex: where the side wall meets the bottom).
Any ideas on what might be the cause?
Thanks a lot!
I'm making some thin-walled containers via stretch blow moulding out of clear PEBA and Nylon 12. On some runs, some of the parts have silvery-white patches on them, especially around bends and edges (ex: where the side wall meets the bottom).
Any ideas on what might be the cause?
Thanks a lot!






RE: White patches on clear parts