Converting splines into arcs and curves
Converting splines into arcs and curves
(OP)
thread561-168453: changing a spline into line/arc segments
Is there a method to convert splines into arcs and curves. In MasterCam there is a convert command but I can find no such command in UG.
UG NX 5.0.4.1
Is there a method to convert splines into arcs and curves. In MasterCam there is a convert command but I can find no such command in UG.
UG NX 5.0.4.1





RE: Converting splines into arcs and curves
RE: Converting splines into arcs and curves