Is there a Tube segment setting?
Is there a Tube segment setting?
(OP)
Hi NX er's
This is just a long shot really as I can't find anything, customer default, but is it possible to change the default setting for tubes from multiple segment to single segment? Our technical illustrators are chewing my bloody ears off about it.
Many thanks in advance.
This is just a long shot really as I can't find anything, customer default, but is it possible to change the default setting for tubes from multiple segment to single segment? Our technical illustrators are chewing my bloody ears off about it.
Many thanks in advance.
Best regards
Simon NX4.0.4.2 MP10 - TCEng 9.1.3.6.c - (NX7.5 native)
www.jcb.com
Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...





RE: Is there a Tube segment setting?
I've found they look better, but can also cause other headaches when single segment.
-Dave
NX 5.0.6.3mp7
RE: Is there a Tube segment setting?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.