Help with adding new lines to an existing GRIP file
Help with adding new lines to an existing GRIP file
(OP)
The company I work for has a GRIP file used to set up drawings. The GRIP file prompts the user through a step by step program that sets up the drawing title block and eventualy gets everything filled in. This includes the part description, rev number, what was updated, the date, etc...
What I need to do is update the GRIP file to include another prompt. What this prompt needs to do is, in short, ask the user for a value of the part and once it has this value put it into a note that will be displayed on the drawing. I am fairly green when it comes to writing GRIP programs and have been looking through some UG GRIP programming manuals. These manuals do not seem to be user friendly. I have contacted my companies Siemens rep and am aquiring a different manual, but any help would be greatly appreciated.
Thanks,
JP
What I need to do is update the GRIP file to include another prompt. What this prompt needs to do is, in short, ask the user for a value of the part and once it has this value put it into a note that will be displayed on the drawing. I am fairly green when it comes to writing GRIP programs and have been looking through some UG GRIP programming manuals. These manuals do not seem to be user friendly. I have contacted my companies Siemens rep and am aquiring a different manual, but any help would be greatly appreciated.
Thanks,
JP





RE: Help with adding new lines to an existing GRIP file
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Help with adding new lines to an existing GRIP file
"I have contacted my companies Siemens rep and am aquiring a different manual, but any help would be greatly appreciated."
The Help documentation has a comple section and some examples of GRIP. Look in the Automation - UG Open.
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT