Perimeter Constraint In UG NX
Perimeter Constraint In UG NX
(OP)
I am creating a closed curve in a sketch and try to use perimeter constraint to constraint the total perimeter of this closed curve. But I cannot do anything. Can anyone hlep me out. The button is there after I click, it only show the dimension dialogue.





RE: Perimeter Constraint In UG NX
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Perimeter Constraint In UG NX
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.