Modelling a structural object surrounded by Fluid
Modelling a structural object surrounded by Fluid
(OP)
Hello all,
I am interested in modelling a structural object under contact surrounded by a fluid to look at FSI in abaqus 6.10. Any tips on how I go about doing this. Anybody done this before or can provide any input. This would be much appreciated. Thanks
I am interested in modelling a structural object under contact surrounded by a fluid to look at FSI in abaqus 6.10. Any tips on how I go about doing this. Anybody done this before or can provide any input. This would be much appreciated. Thanks





RE: Modelling a structural object surrounded by Fluid