RisaFoundation Version 3.0 - Seismic Results
RisaFoundation Version 3.0 - Seismic Results
(OP)
It's me again,
In the previous version of RisaFoundation, I am getting Moments and Reactions which I thought was right because of the Seismic and wind forces calculations from Risa-3D. (Could someone tell me if I am wrong on this assumption). But I've read somewhere in this site that RisaFoundation does not carry over the Seismic results from Risa-3D and that you have to input them manually.
When I upgraded to a much improved version 3.0 with mat foundation and piling and everything, I am only getting Reactions and no Moments. Is this supposed to be the case in Version 3.0?
Does anyone there noticed these?
Regards,
Amanda
In the previous version of RisaFoundation, I am getting Moments and Reactions which I thought was right because of the Seismic and wind forces calculations from Risa-3D. (Could someone tell me if I am wrong on this assumption). But I've read somewhere in this site that RisaFoundation does not carry over the Seismic results from Risa-3D and that you have to input them manually.
When I upgraded to a much improved version 3.0 with mat foundation and piling and everything, I am only getting Reactions and no Moments. Is this supposed to be the case in Version 3.0?
Does anyone there noticed these?
Regards,
Amanda





RE: RisaFoundation Version 3.0 - Seismic Results
I haven't heard anything like that. The most similar concept that I can think of relates to a RISA-3D dynamic analysis. The results of a Response Spectra Analysis will not be brought over into RISAFoundation. That is just one of the current limitations on the interaction between the two programs.