Ansys 12.1 Error SIGSEGV
Ansys 12.1 Error SIGSEGV
(OP)
Hello
I´m modelling a hyperelastic material in Ansys 12.1. I have the uniaxial test data and I´m doing a curve fitting. After I did this and started modelling the problem, an error finished my simulation. It was "An unknown error has ocurred (SIGSEGV)..." and then something about termination abnormally. I think this error has something to do with my Windows XP 32 bit system. Somebody could tell if this is?
Thanks
I´m modelling a hyperelastic material in Ansys 12.1. I have the uniaxial test data and I´m doing a curve fitting. After I did this and started modelling the problem, an error finished my simulation. It was "An unknown error has ocurred (SIGSEGV)..." and then something about termination abnormally. I think this error has something to do with my Windows XP 32 bit system. Somebody could tell if this is?
Thanks





RE: Ansys 12.1 Error SIGSEGV
Regards
Pat
See FAQ731-376: Eng-Tips.com Forum Policies for tips on use of eng-tips by professional engineers &
http://eng-tips.com/market.cfm
for site rules