Validating Scan Data
Validating Scan Data
(OP)
Hi Users,
I'm curious to know how you validate scan data? Our intent is to scan parts, take the profiles, point clouds, etc., them make a paramentric parts. If I have a bunch of imported curves & points, how can I make my model parametric, assuring that my scan curves & points are driving the parmetrics?
Using NX.7.5
I was thinking I could insert hole center points into NX Excel, but how can I use that to drive point locations?
Thanks
I'm curious to know how you validate scan data? Our intent is to scan parts, take the profiles, point clouds, etc., them make a paramentric parts. If I have a bunch of imported curves & points, how can I make my model parametric, assuring that my scan curves & points are driving the parmetrics?
Using NX.7.5
I was thinking I could insert hole center points into NX Excel, but how can I use that to drive point locations?
Thanks
Jason M.
Unigraphics NX Designer




