forcing horiz. alignment of dimensions
forcing horiz. alignment of dimensions
(OP)
For anyone who spends any time in Drafting, this question is probably as dumb as gets but ... would sure appreciate some help. Seems like I've tried every setting.
Thanks
Thanks
Ray S
NX 7.0.1.7
www.appliedprecisionproducts.com





RE: forcing horiz. alignment of dimensions
http://www.eng-tips.com/viewthread.cfm?qid=278777
RE: forcing horiz. alignment of dimensions
Ray S
NX 7.0.1.7
www.appliedprecisionproducts.com
RE: forcing horiz. alignment of dimensions
preferences > annotation > dimensions (tab) > very top middle change to the "lightening bolt" (auto place) instead of the hand (manual placement)"
If the dimension is already down then click on it, rmc (right mouse click) > style > change it to "auto placement" as above
RE: forcing horiz. alignment of dimensions
RE: forcing horiz. alignment of dimensions
Ray S
NX 7.0.1.7
www.appliedprecisionproducts.com
RE: forcing horiz. alignment of dimensions
I was writing previous post before I had a chance to see yours.
Ray S
NX 7.0.1.7
www.appliedprecisionproducts.com
RE: forcing horiz. alignment of dimensions
Companies used to have seed files or drafting templates where all the company default format settings were stored so new Drawings would have correct formatting.
Michael