HELP pls Parts not updating from assemblies
HELP pls Parts not updating from assemblies
(OP)
I am getting crazy over the fact that;
- if i add a hole wizard feature on a part form within an assembly, it does not show on the part when I open this. Strange thing is that i.e. a cut-extrude done the same way, does properly show... as it should do!
Aanyone can help please?
THX
- if i add a hole wizard feature on a part form within an assembly, it does not show on the part when I open this. Strange thing is that i.e. a cut-extrude done the same way, does properly show... as it should do!
Aanyone can help please?
THX






RE: HELP pls Parts not updating from assemblies
- - -Updraft
RE: HELP pls Parts not updating from assemblies
Joe Hasik,
CSWP/SMTL/MTLS
SW 10 x64, SP 3.0
Dell T3400
Intel Core2 Quad
Q6700 2.66 GHz
3.93 GB RAM
NVIDIA Quadro FX 4600
RE: HELP pls Parts not updating from assemblies