lightweight nx7.5
lightweight nx7.5
(OP)
I'm testing a little with nx7.5.1
I have started to load an assembly leightweight contolled from the load option. For navigation I'm often using mark the component in the graphic area and use find in navigator from the selection toolbar. On leightweight data it doesn't work. I want to place the wcs at one of the edge ends of a component- nothing to select/find from the point constructor. Measuring works nice. Is there a setting or something else to know?
I have started to load an assembly leightweight contolled from the load option. For navigation I'm often using mark the component in the graphic area and use find in navigator from the selection toolbar. On leightweight data it doesn't work. I want to place the wcs at one of the edge ends of a component- nothing to select/find from the point constructor. Measuring works nice. Is there a setting or something else to know?





RE: lightweight nx7.5
Customer Defaults -> Assemblies -> Site Standards -> Lightweight Representations
...and that the last item on that page, 'Load Smart Lightweight Data' is toggled ON.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: lightweight nx7.5
maybe I have to recreate the lightweight REps, its a nx6 assy.
another question, in nx7.5 when I add for example the second time (redundant)a fix constraint on a component an message is displayed- in nx6 and nx7 I like to have this Information,too. Is there a setting or something else?
regards
RE: lightweight nx7.5
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.