I want to hide a non-tangent line...
I want to hide a non-tangent line...
(OP)
...that is showing up in my SWx drawing.
SW 2010 - SP 3.1
NVIDIA QUADRO 1700
Dell Precision T5400
8.00 GB RAM
Any thoughts? I had a work-around of drawing a 'white' line over the line in question - but this 'off-colored' line shows up on my print.
I'm not even sure what this line represents. I used the 'loft' feature to connect two bodies.
SW 2010 - SP 3.1
NVIDIA QUADRO 1700
Dell Precision T5400
8.00 GB RAM
Any thoughts? I had a work-around of drawing a 'white' line over the line in question - but this 'off-colored' line shows up on my print.
I'm not even sure what this line represents. I used the 'loft' feature to connect two bodies.






RE: I want to hide a non-tangent line...
RE: I want to hide a non-tangent line...
-Dustin
Professional Engineer
Pretty good with SolidWorks
RE: I want to hide a non-tangent line...
And... yes - sketch for the guide curves is what I'm still thinking though when I turned off the 'show sketches' - it didn't go away.