Creating Tapped Holes on a Taper - Inventor 2010
Creating Tapped Holes on a Taper - Inventor 2010
(OP)
Hi All,
Refer to a Taper Lock Bush.
How can I create a tapped taper hole like those found on taper lock bushes. I have created a blank bush but cannot get the holes to run through at the same angle as the taper.
Any ideas?
Best Rgds,
Dave R
Refer to a Taper Lock Bush.
How can I create a tapped taper hole like those found on taper lock bushes. I have created a blank bush but cannot get the holes to run through at the same angle as the taper.
Any ideas?
Best Rgds,
Dave R





RE: Creating Tapped Holes on a Taper - Inventor 2010
ht
Did you know you can download an iPart for those?
http:
There are some errors in those parts but it is relatively easy to fix. I did model my own a couple of years ago but I left them at my old work.
RE: Creating Tapped Holes on a Taper - Inventor 2010
RE: Creating Tapped Holes on a Taper - Inventor 2010
I have been searching the web for this, including various Inventor sites, but could not find anything.
Still have a lot to learn don't I.
Thanks again
Best Rgds,
Dave R.