NX6 Note leader
NX6 Note leader
(OP)
When I add a leader to an existing note, on a drawing, I am not able to select the edge in the view that I want to attach the leader to. In matter of fact "edge" is not even availabe in the selection filter (only "product definition", "note", "label", "symbol", and "dimension" is) .
I am probably doing something very simple wrong here, but i can't quite figure out what it is.
I am probably doing something very simple wrong here, but i can't quite figure out what it is.





RE: NX6 Note leader
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX6 Note leader
I figured it was something that simple.