creating a 90degree spiral chute
creating a 90degree spiral chute
(OP)
Hello,
I have a project creating a 90 degree spiral chute for a food manufacturing facility. The top conveyor to which the chute takes product from is 24" across and it narrows down and exits to a 18" conveyor. The issue I run into is there is a 11" drop from the top of the chute to the bottom. I have AutoCAD and need to give drawings to our maintenance guys can anyone help?
Thanks in advance,
Eric
I have a project creating a 90 degree spiral chute for a food manufacturing facility. The top conveyor to which the chute takes product from is 24" across and it narrows down and exits to a 18" conveyor. The issue I run into is there is a 11" drop from the top of the chute to the bottom. I have AutoCAD and need to give drawings to our maintenance guys can anyone help?
Thanks in advance,
Eric





RE: creating a 90degree spiral chute
Perhaps a bit more of an explanation of what you're trying to accomplish would help.
Jeff Mirisola, CSWP
Design Manager/Senior Designer
M9 Defense
My Blog
RE: creating a 90degree spiral chute
http
RE: creating a 90degree spiral chute
Thats what we used to do!! NOT that many years ago!!
RE: creating a 90degree spiral chute
RE: creating a 90degree spiral chute
What is Engineering anyway: FAQ1088-1484: In layman terms, what is "engineering"?
RE: creating a 90degree spiral chute
RE: creating a 90degree spiral chute
Please go to the supreme Court in Washington D.c and take a look at the spiral stairs that were built. There is an interesting commentary too about them,more on the lines of suggestion by Kenat. It is just marvellous.