Trying to find a peculiar shape
Trying to find a peculiar shape
(OP)
Trying to find a polymer in shape of hollow cylinder with solid bottom face.
Dimensions of ID, OD need to fall within 32.5-34.5 cm range. Height isn't critical (> ~6 cm).
I've been looking all over and can't find this piece - please save me the $500 it would take to have someone make this.
Dimensions of ID, OD need to fall within 32.5-34.5 cm range. Height isn't critical (> ~6 cm).
I've been looking all over and can't find this piece - please save me the $500 it would take to have someone make this.





RE: Trying to find a peculiar shape
Chris DeArmitt PhD FRSC CChem
www.phantomplastics.com
Consultant to the plastics industry
RE: Trying to find a peculiar shape
TTFN
FAQ731-376: Eng-Tips.com Forum Policies
RE: Trying to find a peculiar shape
You need to search catalogues and the places listed above.
Alternative is to turn it from bar stock. That should not cost anywhere near $500.
Regards
Pat
See FAQ731-376: Eng-Tips.com Forum Policies for tips on use of eng-tips by professional engineers &
http://eng-tips.com/market.cfm
for site rules