I posted the following in the wrong thread-sorry. I'm helping a rancher with a new lake project and we are trying to do some rough calcs on area for his lake. The site is very dense with trees and brush so my Robotic or GPS system is basically useless at this point. I've resorted (keeping in mind I'm looking for rough area calcs at best) to using a hand help Garmin and obtaining GPS Coords from some basic points we know we want to be at or near a water level. I'm able to input the N and W coordinates into Terramodel (ex..32.0000,95.0000) and the results shown on the screen look really good. The problem is that when I try to run a distance from point to point, there is 0.00 value in distance. Area reports result in 0.00 square feet. I've looked at the Coordcon command in Terramodel, but this is the first time I've used direct keyed GPS Coordinates into Terramodel and I don't understand how to convert to either a user defined N-E value or State Plane Coordinate value. Any help would be greatly appreciated.
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
When was the last time you drove down the highway without seeing a commercial truck hauling goods?The ubiquity of these machines underscores the important roll they play in modern commerce. Download Now