Flat pattern
Flat pattern
(OP)
Hi,
I can't able to flat pattern this part.
Half part yes, but with mirror features and unite feature, no.
I don't understand where is the problem.
I can't able to flat pattern this part.
Half part yes, but with mirror features and unite feature, no.
I don't understand where is the problem.
Thank you...
Using NX7.0 and TC8.1





RE: Flat pattern
NX 7.5 Mach Advantage
SE ST2 phasing out
RE: Flat pattern
your solution works fine, but I would like to know why doesn't flat pattern.
Thank you...
Using NX7.0 and TC8.1
RE: Flat pattern
NX 7.5 Mach Advantage
SE ST2 phasing out
RE: Flat pattern
Best Regards
Hudson
www.jamb.com.au
Nil Desperandum illegitimi non carborundum
RE: Flat pattern
I would like understand so I will avoid next time.
Anyway, what you have attached it's the solution that frankbe has mentioned.
Thank you...
Using NX7.0 and TC8.1
RE: Flat pattern
I'm going to file an ER to create a specific "mirror sheet metal body" function to make life easier.
NX 7.5 Mach Advantage
SE ST2 phasing out
RE: Flat pattern
Help give me the procedure to accomplish my task.
Thank you...
Using NX7.0 and TC8.1