i have a planes promblem
i have a planes promblem
(OP)
I have attached a picture to help wot im explaining.
I have 2 half tubes meeting together the problem is i cannot get them to meet.
The sketches are on different planes and angles to one another and i cannot get the jiont plane in the right place.
Im ok when they on on the same plane.
Can anyone please help im in abit of a pickle im use 2005.
I have 2 half tubes meeting together the problem is i cannot get them to meet.
The sketches are on different planes and angles to one another and i cannot get the jiont plane in the right place.
Im ok when they on on the same plane.
Can anyone please help im in abit of a pickle im use 2005.






RE: i have a planes promblem
Alternately, could you build a part in-context of the other in your assembly?
"Art without engineering is dreaming; Engineering without art is calculating."
Have you read FAQ731-376: Eng-Tips.com Forum Policies to make the best use of these Forums?