create a mirrored component
create a mirrored component
(OP)
Folks,
I tried to create a mirrored component, but I could not get it work. I'm going through the entire wizzard, UG creates a new file in the assembly with the corrrect fre-fix ...., but the new created file is empty.
Is there a different set up to use?
I'm running out of ideas. what am I doing wrong?
Thanks in advance.
I tried to create a mirrored component, but I could not get it work. I'm going through the entire wizzard, UG creates a new file in the assembly with the corrrect fre-fix ...., but the new created file is empty.
Is there a different set up to use?
I'm running out of ideas. what am I doing wrong?
Thanks in advance.





RE: create a mirrored component
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: create a mirrored component
How you can see on the picture I tried to mirror the dark green component around one of the planes shown in the picture.
RE: create a mirrored component
Here is the picture.
RE: create a mirrored component
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: create a mirrored component
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: create a mirrored component
with your part it works fine with me, too.
But to make a long story short: here is the assembly I'm dealing with.
Thanks in advance.
RE: create a mirrored component
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.