Floor Load
Floor Load
(OP)
I would like to ask if anybody knows - and if it is of course possible - to exclude members from assigned floor loads.
E.g: when there is a floor with an opening, how can I take the floor out from the opening?
E.g: when there is a floor with an opening, how can I take the floor out from the opening?





RE: Floor Load
Separate the fload and define the X and Z range for each fload.
cmiiw
RE: Floor Load
You might have to make several groups though in order to get around the opening in the floor. Otherwise, you could just make one big group assign the load, and than make another group for just the floor opening and assign the opposite of the load. Therefore, they would cancel each other out.