NX6: ID Symbol arrowhead Integral not associative?
NX6: ID Symbol arrowhead Integral not associative?
(OP)
Hi,
I thought that the new identification symbol arrowhead named 'Integral' could finally remove ambiguity concern we had when identifying components in large assemblies
The unfortunate thing is that it doesn't seem to recognize the component's face it's placed on and finally the balloon value remains empty
Is there a way to automatically get the balloon filled in with the component callout value using this Integral arrowhead without having to go the old tedious manual edit?
Luis
I thought that the new identification symbol arrowhead named 'Integral' could finally remove ambiguity concern we had when identifying components in large assemblies
The unfortunate thing is that it doesn't seem to recognize the component's face it's placed on and finally the balloon value remains empty
Is there a way to automatically get the balloon filled in with the component callout value using this Integral arrowhead without having to go the old tedious manual edit?
Luis




